The HxGN MinePlan product team and Prominas are pleased to announce the release of HxGN MinePlan Activity Scheduler v6.6 and HxGN MinePlan Schedule Optimizer v13.10.1, which come with many improvements and enhancements. Hexagon has worked hard to incorporate your comments and suggestions to ensure this release provides the best possible performance and functionality. We are confident that these improvements will add value to your experience. We welcome your feedback and comments as we continually strive to improve MinePlan to meet your needs. If you have questions about how to install the software, the Prominas Support team is available to support you. Thank you for choosing MinePlan. We look forward to continuing to serve you with exceptional products and services What's New in HxGN MinePlan Activity Scheduler v6.6 What's New in HxGN MinePlan Scheduler Optimizer v13.10.1 To check out more about this and…
Pushback design is one of the most important elements in open pit mining planning. This technique consists of defining excavation phases that are economically viable, safe techniques and strategically organized to optimize resource cleaning. A good pushback design allows you to advance in stages, prioritizing the areas of greatest value and maintaining the stability of operations. By choosing the right design, laurel operations gain in efficiency, mineral utilization and cost control, generating added value to the project. To plan the pushback project, there are different methods that can be applied according to the type of deposit and the objectives of each mining phase. Learn about the Incremental and Directional methods, two approaches widely used in the sector. What are Pushbacks? Pushbacks play a…
Link Viewer – Reserves: Visualization of cuts and topographies inserted in MinePlan Reserves 4.5. Did you know that MinePlan Reserves 4.5, released together with MinePlan 2023 Release 2, has a new option, which allows the user to view the selected cut or topography in its interface? The Link Viewer option, located in the Geometry Cuts and Surface Cuts tabs, makes it possible to highlight selected geometries and/or surfaces on the MinePlan 3D (MP3D) screen. To do this, the user must access Setup Reserves located in the MP3D Reserves menu, insert the desired geometries to perform the cubing and enable the Link Viewer option. Subsequently, when selecting a certain element in the tool interface, it will be highlighted in MP3D, as shown below. Figure 1: Link Viewer option – Mineplan Reserves 4. So, did you like this tip? For more information about the Link Viewer option…